Carpentry
Trim Carpentry, Down To The Millimeter
Trim is where sloppy work shows. Our miters close, our scarf joints disappear, and our caulk lines are straight. Whether you are upgrading builder-grade base to tall craftsman profiles or adding crown and wainscoting, the finish reads as part of the house — not something stuck on afterward.
What's Included
Everything In The Scope
- Removal of old trim and baseboards
- Tall craftsman, colonial and modern flat profiles
- Door and window casing
- Crown moulding and picture rail
- Wainscoting, board-and-batten, chair rail
- Filled, sanded and caulked ready for paint
- Painted finish coat available
Starting At
$6 / linear ft
Installed and ready for paint. Crown moulding and multi-piece built-up profiles run higher; painted finish adds about $2 per linear foot.
Get My Exact Price(206) 555-0142Materials We Use
- Primed MDF and finger-joint pine
- Solid poplar, oak and maple for stain grade
- PVC trim for bathrooms and exterior use
- Paintable siliconized acrylic caulk
Typical timeline
1 – 3 days
Finish
Paint-grade or stained
How It Works
From First Call To Final Walkthrough
The same four steps on every job of this type, so you always know what happens next.
Profile selection
We bring samples and show you heights and profiles against your actual wall and ceiling before ordering.
Remove & prep
Old trim out carefully, walls patched, and any out-of-square conditions identified up front.
Install
Cut, coped and nailed tight, with scarf joints on long runs so nothing opens up later.
Fill & finish
Nail holes filled, joints caulked, sanded smooth and painted if included.
Free Estimate
Tell Us About
Your Project
Send the details and we will come out, measure, and put real numbers on paper. Most estimates land in your inbox within 48 hours of the visit.
- Free on-site visit and written estimate
- Itemized pricing — you see every line
- Licensed, bonded and insured in Washington
- Two-year workmanship warranty
Baseboards & Trim FAQ
Questions About This Service
Do not see your question here? Call us — we would rather answer it now than after you have booked.
Can you match trim in the rest of my house?
Usually yes. Bring us a short offcut and we will source a matching or near-identical profile.
Should baseboards go in before or after flooring?
After, in most cases. That way the flooring gets its expansion gap and the base covers it cleanly.
Do you do built-ins and shelving?
Yes — bookcases, window seats, mudroom benches and closet systems are all finish carpentry we handle.
Also Available
Pairs Well With
PaintingInterior Painting
Walls, ceilings, trim and doors finished clean — with real prep, not just a fresh coat over old problems.
Typical timeline
2 – 5 days
Warranty
2 years
PaintingExterior Painting
Siding, trim and decks prepped for Pacific Northwest weather — washed, sealed and coated to actually last.
Typical timeline
4 – 8 days
Best season
Apr – Oct
TileTile Installation
Showers, floors, backsplashes and fireplace surrounds — set flat, waterproofed properly, grouted tight.
Typical timeline
3 – 7 days
Waterproofing
Schluter / RedGard